Norris Planes

A post war coffin shaped A5 smoothing plane made by Norris of London with ebonised beech infills. Has a good length Norris parallel cutting iron with 33mm of blade left to slot. Lever cap and brass knurled blade adjusting knob are also marked Norris London. Plane body has some marks through use, sole is marked with some scratching that is clearly visible though hard to feel if you were to run your hand across the sole of the plane. Infills have some loss of finish through use and are marked with the previous woodworkers name stamp.

A parallel plane iron made by Norris, London.

A lovely 17 ½" A1 dovetailed panel plane made by Norris London with ebonised infills. This lovely infill plane retains a near full length parallel plane iron. Lever cap, plane iron and lateral blade adjuster are all marked with the Norris London stamp. Infills retain an estimated 95%+ of the original finish, edges of plane also retain some of the original protective coating. The sole is marked with some very minor spots of pitting and 2 patches of pitting (see photos). This collectable plane comes complete with the original Norris box (box is worn).

Little Norris Bullnose plane no. 25 with rosewood wedge. Retains a near full length cutter marked Norris London, cutter is also marked a patch of pitting, retains rear screw. This old Norris bullnose plane has some light scratching and a number of visible dents. All parts original, blade wedge and body are all marked ‘9’.

Please contact old tools if you would like to see higher resolution photos of this woodworking plane.

A fine little used 14 1/2" panel plane made by Norris London. This lovely post war plane retains a near full length parallel plane iron. Lever cap, plane iron and lateral blade adjuster are all marked with the Norris London stamp. Infills retain an estimated 96%+ of the original finish. This collectable plane comes complete with the original Norris box (box is worn with faint writing to lid and worn edges).

A lovely dovetailed shoulder plane no. 7 made by Norris of London, with rosewood wedge and infill. Has a good length snecked cutting iron. Body, wedge and cutter are all marked with the assembly mark '2', the snecked cutting iron does not have the makers stamp though is marked '2'. Sides and sole are marked with some very light patches of pitting and light scratches. Good clean mouth.

A nice dovetailed shoulder plane no 7 by Norris of London, with rosewood wedged and infill. Retains a good length snecked cutting iron. Body, wedge and cutter are all marked with the no 1. Rosewood infill and wedge are lightly marked with the previous users name stamp. Body has some very light speckling of pitting/staining, sole of the shoulder plane has clean crisp edges. A nice old Norris woodworking plane in good condition.

Sole Length: 200mm (7 7/8”)
Sole Width: 24mm
Mouth Depth: 1.5mm

A late 14 1/2" A1 panel plane made by Norris, London. Retains a near full length Norris iron, lever cap and lateral adjuster are both marked Norris London. The beech infills have some loss and flaking of lacquer, the rear infill has a hairline shrinkage crack around the top of the handle (see photo). The body of this Norris panel plane has some staining marks, scratches and a couple of light patches of minor pitting.

Please contact old tools if you would like to see higher resolution photos of this Norris woodworking plane.

Norris 50G brass and steel soled coffin shaped smoothing plane with mahogany infill and handle, brass scew down lever cap and Norris steel iron.